To fly with BMS and DCS

Starting with the front panel

Electric tools used



Made out of 1/4" plywood, I don't have a clue if the measurement are right, i"m pretty sure they are not, lots of pics online but no measurement, it's built around a 22" monitor


Fitting the monitor



Primed


Started to work on the UFC panel, used two key pad ,cut them in half to have all the needed push button, glued them together and added plexiglass on each side





I find that if you could have one original part of the front panel it would make it a lot easier to figure things out even if it's only a gauge, I checked ebay but there was nothing


Don't know why some images are not showing right, sorry

Marc..