Posted By: Genbrien
Triple monitor FOV problem - 09/16/18 05:52 PM
Hi!
just made a triple monitor setup this week.
I cheked how to change the FOV to 120, wich is working, but my problem is that as soon as I zoom in, I cant zoom out to 120 and stuck with a lower FOV
Is there something that can be done or its a BMS limitation?
Posted By: DBond
Re: Triple monitor FOV problem - 09/17/18 12:50 PM
I don't use multiple monitors so cannot be sure, but I seem to remember reading about this issue, and as I recall the fix was to change both the default and the max FOV
set g_fMaximumFOV 80
set g_fDefaultFOV 80
If you've already done this, or if this does not do the trick I am already out of ideas.
Posted By: DBond
Re: Triple monitor FOV problem - 09/19/18 12:23 PM
I've always wanted to be a guru.
Posted By: santinif4
Re: Triple monitor FOV problem - 10/25/18 01:11 AM
Where do I make that change at exactly?
Thanks
Posted By: DBond
Re: Triple monitor FOV problem - 10/25/18 11:44 AM
BMS directory>User>Config>FalconBMS.cfg is the spot.
Welcome to SimHQ Santini.
Posted By: Genbrien
Re: Triple monitor FOV problem - 01/07/20 02:52 PM
and is there a way to change the default view position?
if you enter cockpit, its centered on your hud, seeing half sky, but only top of your cockpit, having your MFDs out of view.
Would it be possible that the default view a tilt down so top most of the screen is the top of the HUD, so I could see the whole cockpit by default?
