#3344310 - 07/18/11 09:07 AM
Re: SAM Simulator
[Re: Hpasp]
|
Joined: May 2011
Posts: 139
Kairo
Member
|
Member
Joined: May 2011
Posts: 139
Algeria
|
humm .. work, tourist or live on this town?
there is some think there ..
Sgt/C. Kairo
|
|
#3344314 - 07/18/11 09:20 AM
Re: SAM Simulator
[Re: Kairo]
|
Joined: Dec 2009
Posts: 2,665
Hpasp
Senior Member
|
Senior Member
Joined: Dec 2009
Posts: 2,665
Hungary, Europe
|
I have observation about a lot of keys, switches, knob, and others who are not in use, and so no details or info about them, some explanation ?
are they planned for future for more realistic use? Some of these are for initial system check, some are for systems that are not modeled. 1...4, I do not know by hart, should be checked. 5...10, are for ARU/MARU/RRU controls. Not simulated. (auto/manual gain) 11, Angle synchronizer input source. (used during maintenance only.) 12, Missile tracker mark check switch. At the Volhov you can see the 3 missile tracker mark at the bottom of the I32V indicators. At the Neva they are "below" the screen. When you switch it, they jump forward, to the screen. (used during maintenance only.) 13, Ask electricity from the generator operators. They have a lamp that illuminates if this is pressed. (never used in Hungary) 14, Karat target tracking camera is switched on indicator.
Last edited by Hpasp; 07/18/11 09:21 AM.
|
|
#3344322 - 07/18/11 09:34 AM
Re: SAM Simulator
[Re: Kairo]
|
Joined: Jun 2011
Posts: 191
MK_PL
Member
|
Member
Joined: Jun 2011
Posts: 191
Poland
|
A family member was working there, I came for holiday. humm .. work, tourist or live on this town?
there is some think there ..
|
|
#3344328 - 07/18/11 09:50 AM
Re: SAM Simulator
[Re: Hpasp]
|
Joined: May 2011
Posts: 139
Kairo
Member
|
Member
Joined: May 2011
Posts: 139
Algeria
|
others who are not in use also, and no info about them, some explanation ? and some indicators who seems works but need some deep explanation
Last edited by Kairo; 07/18/11 10:19 AM.
Sgt/C. Kairo
|
|
#3344332 - 07/18/11 09:58 AM
Re: SAM Simulator
[Re: MK_PL]
|
Joined: May 2011
Posts: 139
Kairo
Member
|
Member
Joined: May 2011
Posts: 139
Algeria
|
A family member was working there, I came for holiday.
you'r welcome, I also have a family living there, but I live 1200Km far from them, I see them only on big holidays. (I see you haven't put your country!)
Sgt/C. Kairo
|
|
#3344368 - 07/18/11 11:03 AM
Re: SAM Simulator
[Re: Kairo]
|
Joined: Jun 2011
Posts: 191
MK_PL
Member
|
Member
Joined: Jun 2011
Posts: 191
Poland
|
I live in Poland. A family member was working there, I came for holiday.
you'r welcome, I also have a family living there, but I live 1200Km far from them, I see them only on big holidays. (I see you haven't put your country!)
|
|
#3344372 - 07/18/11 11:16 AM
Re: SAM Simulator
[Re: Kairo]
|
Joined: Dec 2009
Posts: 2,665
Hpasp
Senior Member
|
Senior Member
Joined: Dec 2009
Posts: 2,665
Hungary, Europe
|
others who are not in use also, and no info about them, some explanation ?17...18, PU drive 16, used during PU drive maintenance 15, 19, PU maintenance 14, used during target search maintenance
|
|
#3344378 - 07/18/11 11:27 AM
Re: SAM Simulator
[Re: Kairo]
|
Joined: Dec 2009
Posts: 2,665
Hpasp
Senior Member
|
Senior Member
Joined: Dec 2009
Posts: 2,665
Hungary, Europe
|
and some indicators who seems works but need some deep explanationh1, h2 is the same as in the Volhov. It shows how far were the missile from the target (in the two plain h1/h2), when it exploded. With 9, you can select between the two missile. 1...5 here you can launch electronic target, and missile for practice. (this is not simulated, but these are on the to-do list 6...7 used only during maintenance 8, +26V circuit breaker (we are getting too deep 10, maintenance mode selector IM, magnetron heater current indicator Different current is needed for 40km and for 80km. ID, receiver sensitivity indicator. (working only during maintenance) Phew...
|
|
#3344387 - 07/18/11 11:55 AM
Re: SAM Simulator
[Re: Hpasp]
|
Joined: Jun 2011
Posts: 191
MK_PL
Member
|
Member
Joined: Jun 2011
Posts: 191
Poland
|
Hpasp, sorry for new suggestions... but since there is so much information in this forum (e.g. in your last posts) maybe it should be included in the manuals or in the sim itself?
Last edited by MK_PL; 07/18/11 11:56 AM.
|
|
#3344568 - 07/18/11 03:16 PM
Re: SAM Simulator
[Re: Hpasp]
|
Joined: May 2011
Posts: 139
Kairo
Member
|
Member
Joined: May 2011
Posts: 139
Algeria
|
Last edited by Kairo; 07/18/11 10:14 PM.
Sgt/C. Kairo
|
|
#3344715 - 07/18/11 05:20 PM
Re: SAM Simulator
[Re: Hpasp]
|
Joined: Jan 2011
Posts: 58
Redcoalition
Junior Member
|
Junior Member
Joined: Jan 2011
Posts: 58
Brazil
|
I'm very sorry, but I still didn't understand everything that was explained... I will have to repeat few questions 5...10, are for ARU/MARU/RRU controls. Not simulated. (auto/manual gain)
Sorry but, what's ARU/MARU/RRU? I searched for it on manual, didn't found, and don't remember this being told on older messages. They are for initial SNR setup at a new place for Geodetic measurements.
So it measures the local geomagnetic interference for correction or what? 3, target acquisition mode selector In the beginning, these systems (SA-2/SA-3) were shipped without target acquisition radars (P12/P15/P18). So they can be used like an acquisition radar. This mode is not simulated with the Neva, but you have it in the Volhov. (not documented So the RSN-75V3-OP can be used as a acquisition radar? How it works, where can i find it?! Look promising! Once again Hpasp, sorry for disturb with these silly doubts. I really admire your work, maybe especially because my country don't have any ground based radar air defense system, just som EW radars, neither did i served in the Army! So I sorry if we expect a full simulator of every role in a SAM Battery... But's such a poorly explored area that I wait for a full simulator, that can show the greatness of this "job", even knowing that it's impossible... Anyway, your work is still the best, by miles, in this area of civilian simulation of SAM and I'm very grateful for your "present", and for your great explanations here in the topics... Keep the great work!
|
|
#3344795 - 07/18/11 06:29 PM
Re: SAM Simulator
[Re: Hpasp]
|
Joined: May 2011
Posts: 139
Kairo
Member
|
Member
Joined: May 2011
Posts: 139
Algeria
|
may be i can answer this first: They are for initial SNR setup at a new place for Geodetic measurements.
So it measures the local geomagnetic interference for correction or what? I think it measures no think, it just indicates simply if the SNR orientation (or alignement) is well ( right), with no offset between him and display scope, because when we put SNR in new location after displacement, we must calibrate his orientaion with instruments in Ynk cabine, we use this instrument for that, to avoid false azimuth indication (real target 240° - SNR Scope 245°: for example!) Right??
Last edited by Kairo; 07/18/11 10:17 PM.
Sgt/C. Kairo
|
|
#3344835 - 07/18/11 06:56 PM
Re: SAM Simulator
[Re: Hpasp]
|
Joined: May 2011
Posts: 139
Kairo
Member
|
Member
Joined: May 2011
Posts: 139
Algeria
|
I can answer also this: 3, target acquisition mode selector In the beginning, these systems (SA-2/SA-3) were shipped without target acquisition radars (P12/P15/P18). So they can be used like an acquisition radar. This mode is not simulated with the Neva, but you have it in the Volhov. (not documented So the RSN-75V3-OP can be used as a acquisition radar? How it works, where can i find it?! Look promising! the answer is already in the Volhov-ENG-V2 Manual Page 17, read the last line! but this answer steel need deep explanation from Hpasp, because no more details is in the manual about that (I think!) - may be is the methods in Page 22 "Target Acquisition using Wide Beam mode", I'm not sure! - So they can be used like an acquisition radar. This mode is not simulated with the Neva
for Hpasp : some planing to be add in future -in to-do list-?, because there is the real world-
Last edited by Kairo; 07/24/11 04:43 AM.
Sgt/C. Kairo
|
|
#3345092 - 07/18/11 10:55 PM
Re: SAM Simulator
[Re: Kairo]
|
Joined: Jan 2011
Posts: 58
Redcoalition
Junior Member
|
Junior Member
Joined: Jan 2011
Posts: 58
Brazil
|
may be i can answer this first: They are for initial SNR setup at a new place for Geodetic measurements.
So it measures the local geomagnetic interference for correction or what? I think it measures no think, it just indicates simply if the SNR orientation (or alignement) is well ( right), with no offset between him and display scope, because when we put SNR in new location after displacement, we must calibrate his orientaion with instruments in Ynk cabine, we use this instrument for that, to avoid false azimuth indication (real target 240° - SNR Scope 245°: for example!) Right?? Looks like this is the real explanation! Many thanks!
|
|
|
|
|
|
|
|
|
|
|
|
Exodus
by RedOneAlpha. 04/18/24 05:46 PM
|
|