After some Offtime in flying I discovered the following problem on my Cougar. When I move the throttle axis all the way back, it ends up with a value of 26 (raw signal). When I move it completly forward, I get 0 as a value. I searched around and found this doc on the TM-website:
Yes, I did a reflash but the problem remains. I also discovered that the ANT-Wheel gives strange values. In an other forum I read that the Cougar needs this one to work properly, can anyone confirm this? BTW In Cougarwolrd often solutions were linked to frugals. Since it was shut down there seems a lot of info lost. Is there an alternive to frugals?
ASUS ROG MAXIMUS VIII HERO, i7 6700k, G.SKILL Ripjaws V Series 32GB, 980TI 6GB G1 OC, Obutto oZone, Thrustmaster HOTAS Warthog, CH Pro Pedals, NP TrackIR5, ***Soon*** Oculus Rift
I had the very same problem and it was caused by a bad ANT pot (mine was pretty much dead) , I worked it around by deactivating ANT pot in the control panel while i was waiting for the replacement part. Once the replacement arrived (it costs 8 euros shipped from guillemot /TM assitance ) i soldered it in place and reactivated the ANT axis. IF you have money and time i would suggest to upgrade TQS throttle with hall sensor and metal bearings.
"When you plan revenge best dig two graves" Confucius "They who can give up essential liberty to obtain a little temporary safety, deserve neither liberty nor safety" Benjamin Franklin
an home made mod few quids (less than 5 $) if you are not "technically challenged", the kit should be around 100$ (but i don't remember honestly), but i would ask to someone who choose this path.
"When you plan revenge best dig two graves" Confucius "They who can give up essential liberty to obtain a little temporary safety, deserve neither liberty nor safety" Benjamin Franklin