Just re installed AF and up to 1.07.

In Air to Air RWS I am having difficulty bugging or locking a Target. After placing the cursor of the target and pressing Numpad 0 nothing happens. All I get is the reduced Azimuth scan lines but no lock. Is there something Obvious I am stuffing up here ?

IvanK, you say nothing about switch settings, realistic/simple mode or range of the radar. I have found that in realistic mode, I place the cursor over the target and then wait for the altitude to be displayed before bugging. I also hold the numpad 0 for at least 1 sec to be sure to get the lock. The lock occurs when the key is released. Hope this helps.

Yes, make sure the two-digit altitude reading below the contact appears. And also, not all returns can be locked, due to range, jamming and other things.

Danke