Hi all,
A few updates.
I'm working on the fuselage internals and the engine.
The fuselage halves were two-tone, as were the cockpit side frames.
The engine bearer frame was a single colour.
As I normally do, the slight weathering effect was done using the 'Flory Models' dark dirt clay wash.
The rudder, elevator and ailerons control lines were added using 0.08 mm diameter mono-filament and blackened 0.4 mm diameter tubes.
Other detail, such as pipes, seat harness etc will be added after the cockpit assembly is built and before closing up the fuselage.

The next stage, after completing the engine is to assemble the fuselage,

Mike







Here's the engine.
As most of the engine won't be seen, it's just the basic engine with the addition of ignition leads and the pipe at the front cylinder.
The replacement exhaust pipe is from 'ReXx',

Mike