This is my first post here after having read all the huge 102 pages of this thread.
So, I need your help!
Having some Arduino Micro, I wanted to make a first try with just one switch and 1 pot before going to a more challenging project, but if I don't have any problem with switches, I am not able to have any pot working. I tried different versions of the software, differents pots and different entries, but still nothing with this pot...
Here are my wiring and my setup attached. Can you see any mistake?
You don't Arduino Pin Names with MMJoy2 , you have to Use the Pins as Defined by Mega-Mozg in the MMJoy Firmware...
The pics below are in the thread , so I am not sure how you missed that Info but the info below should get you started....