Hi Rob, When the wings were removed for transportation, they were stacked vertically on the leading edges as they were the strongest edge. 'Bump stops' ('stacking pads') were fitted into the leading edges to keep the leading edge surfaces clear and prevent any damage. On the wing leading edge, you can just make out these pads, one fitted to each side of the wing, forward from the wing strut mountings.
The lower wing is finished now, with the trailing edge wire fitted and overall 'dumbing down' carried out using 'Alclad' Light Sheen lacquer mixed with 'Tamiya' Smoke (X19).
So now it's on to scratch making the undercarriage fairing and axle assembly (not available as a 3D printed part),
Mike
Alienware Aurora R5 Windows 10 64 bit Intel i7-6700K 4.2Ghz Two GTX 1080 Foundations in SLI (8 Gig each) 32 Gig DDR4 2133Mhz 1TB SSD boot drive - 1TB SATA storage drive 5.1 Surround Sound 34" Dell Ultra Sharp U3415W (3440x 2440) CH Pro-Pedals, Stick and Throttle TrackIR-5 Pro