Hi all, The leading edge plywood 'saw tooth' fairing is tricky to do, but can be done. Structure drawing of 1/72 scale resized by 160%, then printed, cut out and used as a template on 0.2 mm thick plastic card. The fairing is test fitted and adjusted where necessary then secured in position using thin CA adhesive. Starting on the top of the front wing spar then once set, rolling the wing over the fairing and applying adhesive at the same time.,
Mike
Alienware Aurora R5 Windows 10 64 bit Intel i7-6700K 4.2Ghz Two GTX 1080 Foundations in SLI (8 Gig each) 32 Gig DDR4 2133Mhz 1TB SSD boot drive - 1TB SATA storage drive 5.1 Surround Sound 34" Dell Ultra Sharp U3415W (3440x 2440) CH Pro-Pedals, Stick and Throttle TrackIR-5 Pro