Sokol1 I know (post #4352621) is quite old but after using my button box for some time for the pots for trimming aircraft I certainly now understand your comment. A multi turn would improve trim so much by reducing sensitivity!
Originally Posted by Sokol1
What is advisable use for trim is multi-turn - ideally 3 turn type pot, for allow fine adjust of trim. This kind of pot use gears to reduce the knob rotation over pot axis, allowing the desired precision.
The multi turn pots are a bit expensive but I will go that way way if necessary. Just wondering if any other possible method/s to adjust axis. My thought is that TLE5010 would not improve the trimming sensitivity over a pot?
I know this may be a silly question but could a trim axis be controlled by an encoder. In my mind the answer is no (I have no technical knowledge for that deduction) but I thought I might just check with the more knowledgeable people.
