Hi Rob,
Those bits are tricky due to the small size and restricted working area.
The wings rigging should be a bit easier as I've pre-rigged the upper wing, so that's half the job.
The nickel-silver micro-tubes and aluminium nuts are secured in the model and to the rigging line using thin CA adhesive, so it'll take a fair bit of tension.
I normally fully tighten the lines, after they're installed, using heat applied along the line, which shrinks it to take out any slack present.
As long as I don't get too close to the line or model of course!!!

Mike


[Linked Image]

Alienware Aurora R5
Windows 10 64 bit
Intel i7-6700K 4.2Ghz (liquid cooled)
Two GTX 1080 Foundations in SLI (8 Gig each)
32 Gig DDR4 2133Mhz
1TB SSD boot drive - 1TB SATA storage drive
5.1 Surround Sound
34" Dell Ultra Sharp U3415W (3440x 2440)
CH Pro-Pedals, Stick and Throttle
TrackIR-5 Pro