Originally Posted by JJCTHMFS
[quote=Kbird][quote=JJCTHMFS


srry for the typo I meant to write "print" and i live in Argentina and it take sooo long and It gets expencive, so I was thinking about doint it with prints or asking some local board manufacture.

http://SimHQ.com/forum/files/usergals/2015/03/full-37484-99132-tle5010_42_13.png


You can theoretically make your own single layer PCB but be careful with the Chemicals used , there are many tutorials online now like at Sparkfun
https://www.sparkfun.com/news/2116

In the MMJoy2 Folder you will find the PCB Folder with some example .Lay6 files which can be opened with Sprint Viewer .....Sprint Viewer (not Demo) will allow you to Print them to PDF, I used them to make my own Shift Register Boards with 2x 74HC165chips but I just used ProtoBoard for them , I didn't etch my own.

Note that different MMJoy2 Firmwares come with different PCB examples and not all of them are 100% correct.

The Magnets need to be Diametrically magnetized , 6 or 8mm round will work slightly larger if it has a hole in the middle for mounting.
If you buy the TLE Boards from AliExpress, they come with the magnets.

Most of this Info is in the Thread too, especially from when I started my 1st Conversion and had all the same questions , I think I started here about page 119 ....
Magnet info page 138=142 ?

KB.

Attached Files Magnetic Poles.jpg
Last edited by Kbird; 10/17/18 04:37 PM.

My FLCS+TQS Conversion here on SimHQ

http://simhq.com/forum/ubbthreads.php/topics/4324940/1