Originally Posted by sunrrrise

Unfortunatelly this pic has too little details frown


But the picture have all one need for wire Warthog grip - pins for wire each button group (HAT), that have one common Ground wire - Ground is shared in PCB with all buttons.

What can confuse is if one don't know what is the names used by Tm, e.g. CMS, DMS, Pinky...

But this names don't matter, because is translated in buttons numbered from 1 to 24 plus POV HAT (4 buttons).

For whatever reason Tm don't use the buttons number 6, 13, 14, 15, 16, so 24 - 5 = 19 buttons + POV HAT (4).*

And finally, for games don't matter if trigger is button #1 or #8 (like Warthog) or #23 - only matter for Tm TARGET.

The only buttons that need use original pins location is POV HAT, because in POV HAT two buttons near pressed simultaneous create a virtual diagonal button in firmware.

In MT-02 you have 6 pins, 5 for buttons (4 way + push and one common, what can use e.g. CMS and CMS down in the picture - just use 1 ground wire, Tm use 2 for convenience.

* Curiosity: Tm F-18'ish grip (WiP) will have the same number of buttons than Warthog, due push in buttons in two HAT's and a extra 'slider' with up, down and push.