EjctEject how do you have your opentrack set up?
Just make sure you have the correct model dimensions under the point tracker.
Run the calibration routine for the model position
Then adjust the curve mapping to your liking.
I use about 30 for yaw at 180 degrees
15 for pitch at 90 degrees
Roll is 50 at 40 degrees
X and Y are 15 at 70 degrees
Z uses Asymmetric Mapping, the top is disabled, prevents zooming out, the bottom section is 5 at 0 degrees and 20 at 70 degrees.
And I should add, the curves are all subjective, I'm running triple screens, so the movements can be smaller since it's running 120 degree FOV.
