The only consistent theme between them all is that they indicate that MISO is no 14 pin but sometimes referred to as B2 or B3. This is important as you need to set in software.
I actually had it on pin 14 but then changed it to pin 16 as I have generally gone by the pin diagram linked on 1st page of this thread..
I will change back to pin 14?
MISO is 3rd from bottom on RH side in all the Pinouts I have as well as the MMjoy one, and is B3 on all the MMjoy docs I have seen... see the Wiki ...linked below....
Per the 2nd image above Pin16 is MOSI not MISO..... also see other PinOut I have below , I also found another Image I have that has Pin14 as B2 but it is not clear if that is a MMjoy2 layout, ( it has something called EIXOS?? labelled on it) so I won't post it either since the official pinout below and second image above agrees with the MMjoy (MegaMozg's) Pinouts on the Wiki and posted just above.
The MISO vs MOSI is more important than the B3 or B3 designation I think . The SPI Pins are how the Arduino handles data in and data out , ( (MISO)Master In Slave Out and (MOSI) Master Out Slave In ) and as I was using a Leonardo I didn't even notice the B2/B3 designation on that Yellow Image, I just wired for MISO which is B3 on all the Images I have for the Leonardo and on the MMjoy Wiki Here :
My Pedals I just rewired and made USB , and connect them to my TQS via a gameport connector/cable , nothing special but I thought you might see how the wiring was done originally for the toe brakes. Never was that fond of the CH pedals but I have ended up with 2 pairs of them as part of a deal for a 2nd FLCS and TQS, but was thinking I may convert the 2nd pair to something witth a wider stance etc when I have time at some point.
