Well it looks like I may have managed to get it working - I think..
I actually decided to load Windows 10 due to Microsoft dropping support on new Gen 7 Mboards. It actually seems to work and load quicker on new board in comparison to W7.
I am yet to test button box but I just finished looking at the Pro Micro for the rudders (which was showing as a problem in DM in W7) and this time there was no issue in DM (Device Manager). So I tried a Firmware update and it went through - although it does not show as I expected in USBDview.
It would seem there was some issue in previous load of W7 between new Mboard/W7/ and MMJoy or something did not load correctly.
See attached file. Would it seem to others that it worked? It will be a few days again before I can attack the wiring of sensors to board.
