I try to configure the panel, but I don't, know how .
I upload the firmware (i Think) because, I run the bootloader appear the com port in the device manager , but I didn't see the dos windows to run install. but something was running just a sec.
After that I run the configurator softver I recognise the device, but I don't see any buttons there, and the configurator show the panel when I push "save set to device " the message is: configurator version doesen' meet the firmware version.
I donwload the latest 20161101 and I setup the firm from there.
The handle is connected whith shift reg , How can I set up the buttons on it?
It sounds like you have mixed the Firmware and the Configurator software versions , ( eg firmware is 2016-8-18 and Configurator is 2016-11-1) but when you see the port number change you need to hit the upload button in the Configurator on the Firmware Panel unless you have the check box ticked to AutoStart upload automatically and have previously put the correct COM Port Number in the Port(arduino) Box.
