I try to configure the panel, but I don't, know how .

I upload the firmware (i Think) because, I run the bootloader appear the com port in the device manager , but I didn't see the dos windows to run install. but something was running just a sec.

After that I run the configurator softver I recognise the device, but I don't see any buttons there, and the configurator show the panel when I push "save set to device " the message is: configurator version doesen' meet the firmware version.

I donwload the latest 20161101 and I setup the firm from there.

The handle is connected whith shift reg , How can I set up the buttons on it?