However I also see them on the 2016 SMD version on the 0k ohm VCC resistors , why would they be needed there ? I would of thought the resistor is enough or is that a error on that schematic like the missing 10k ohm resistor on Miso? KB
No Kbird, it is OK, no error, wire jumper or 0k ohm resistor is the same solution. It`s OK. You can use wire jumper if you need to connect some routes not very close. Or you can draw these routes one next other very close and use SMD resistor with value 0 Ohm so it is like wire, no resistance, do you understand? It`s only about designer.
