I have connected both the 15 pins (Chip enable) to GND on my 16bit SR Board as I copied a later Schematic from 2016 for a SMD '165 Board and I did notice the White lines ("connects") in Sprint Viewer in the DIP version but I had already done them.
However I also see them on the 2016 SMD version on the 0k ohm VCC resistors , why would they be needed there ? I would of thought the resistor is enough or is that a error on that schematic like the missing 10k ohm resistor on Miso?
I will have to play with MMjoy and figure out why 37 and 38 don't show in VKB but do in MMjoy , it does sound like a setup issue in MMjoy except those buttons in MMjoy can not have Modes or Timers assigned , so I thought they should just shoe as Normal buttons. I would not of noticed , except now I have the SR PCB working , I have 16 extra Buttons now and 12 (rotary switch) need to be under the 32 button no# limit for buttons with applied Modes+timers .
