I was who remove those pins, but I don't know what its name those header because the yellow maked pin header is smaller than red ones. So I should be one male and 6 female header from this type. And one par the red marked, but I want it 90 deg version that it doesn't break it in use.
If you have pics about the wires from shift reg to buttons, it will be good. Becouse my grip is totally wrong and it is soldered with scan matrix with diodes, but I want to soldered back the original state
I have individual TLE 5010 chip so I didn't order from Ali that's way ask that this magnets good or not.
There was never any pins at the RED marked area , (See pic below) the wires were soldered direct to the PCB , I added Pins to my PCB because the original soldeering and wires kept breaking while I was working on the handle, but it is the same pins on my board , you can just separate them off the snappable header into single pins with your cutters , they also come in 90° too , I used 90° pins to modify 2 Leonardos' so they would fit into the FLCS and TQS easier as the Pro Micro's I ordered for that have never turned up from China.
