Thanks Sokol and AndyB,etc , I asked about 25 pages back (#123) about the orientation of the magnets as I could not find a guide online on how to install the TLE5010 and the magnets as I had assumed flat as suggested but ended up following Penzija's method on page 115 where he installed them in an X45 as I could not find any other good examples , my 1st attempt did not work (#124) as the Pot would not rotate smoothly with the Pot Cup put back on after I drill it out to accept the magnet holder I made from a Pen Shaft, so I removed the Pot Cup and added the Spacers instead. . http://SimHQ.com/forum/ubbthreads.p...uild-your-own-usb-controller#Post4326840
Erichos , do you have photos of your maount TLE5010 and the magnets you could share please ? I remember youmentioning you had mounted them on the Pot shaft in a CH Stick too.
I will swap out the Board since I have a spare and try that 1st , if no success I guess I will try remounting the magnets flat as suggested.
