I got pots at start of this process when I knew that pots and joysticks were something used together and nothing more
I tested pots in sim (CLOD) and they work and have them as X,Y,Z following KB's advice.
But do I have wrong type of pots for using with Surface Trims, as these are linear!!
Or is there a setup ability in MMjoy?
Also 1 of them in particular seems to be very jittery?
As in Sliding Pots ? like used in the CH Throttles? not a Rotary Pot ? there is a Slider Setting for Axis's for using with those type of throttles/axis but I think you can only use the setting once? .... try it
turn the filtering up on Pots to something like 10 , see if that helps ...7-10 helps here but older / worn ones may need higher though. You may need to recalibrate slightly when you change the Filter level .
KB
They are rotary and in sim seem to produce a linear effect - just like throttle
