Hi , I am having a wiring issue I believe , the TLE5010 Boards are installed and Working fine , the 4021 Shift Registers in the Handle are working fine too ....BUT only if I don't connect them at the same time , ie the TLE5010 are working or the Buttons in the Handle are working but not both at the same time . From the information below from earlier in the Thread my understanding is that i can connect all the wires together to their appropriate Pins except CS , which each have their own Pins , and the 2 Gen wires from the TLE 5010 Boards , they are wired together and then go to B6 on the Leonardo.
I am not sure if the Handle Wiring in the FLCS is the Same as the Cougar , I found the image below online , perhaps that is the issue and the colours are different in the FLCS? ( I thought FLCS,F22 and Cougar were the same though?)
From Earlier in the Thread.......
As mega_mozg_13 wrote you need to connect: "B6" for TLE5010-GEN - this pin are shared for all TLE5010/5011 sensors.
"B3" for SPI-MISO - this pin are shared for all "SPI" sensors (TLE5010/5011/kma200/mcp3201-3208). "B1" for SPI-SCK - this pin are shared for all "SPI" sensors (TLE5010/5011/kma200/mcp3201-3208).
"SPI-CS" - you can connect as you like, and where you connect CS-pin need to setup at configurator. this pin are individual to sensor. (F4 & F5 - just a sample).
also additional data line "SPI-MOSI" shared for "SPI" sensors mcp3202-3208. ... if you did not use IC MCP3202-3208 you do not need pin SPI-MOSI and you can use this pin for button matrix or like CS for TLE5011 and so on...
Use saved calibration not auto calibration for TLE5011.