These settings ok? - Saved without Center ( or with?) - Precision 10 ( saw a vid on Youtube with it set to 14? ) - Filter ? Should I need this? currently on 7 to show no jitter in VKB JoyTester ...one is better than other though
- note I still have original pots hooked up too, as I was thinking I could use them perhaps as MMjoy Axis Special Functions and assign buttons or something else to them , or even use as throttle and Rudder if TQS is not in Use.
KB
Hi Kbird, Saved with center - you need for joystick, of course, you need center or not? And Saved w/o center is for throttle... when you do not need center position, ok? Precision- for TLE5011 set 14-bit (because TLE5011 has own ADC), for pot only 10-bit because you use internal Arduino ADC and it is only 10-bit precision, ok? Filter- value 0 means - without filtering, so for TLE5011 I usually use value 3-4, for new pot too, for old pot 7...you have to try it, it is clear I think. You can use Death zone if you want, eg. DZ low - DZ center - DZ high: 1-1-1. Sometimes 1-2-1 is better for some joystick gimbals. You have to try it too. Bye.
thanks again Erichos...
- I wasn't sure if "Center" worked with the TLE 5010 chip or not , so I'll set Center...
- I thought 14 was correct ( per video ) but the Wiki says to use 10 unless using a MCP3208 and then use 12
- Ok I have Filter on as you suggest , I just wasn't sure it was or should be needed with a digital chip , or if I may have bad wiring or bad magnet position or ???
- Thanks for Tip on the Dead Zone too that will be helpful for me I think.
