These settings ok? - Saved without Center ( or with?) - Precision 10 ( saw a vid on Youtube with it set to 14? ) - Filter ? Should I need this? currently on 7 to show no jitter in VKB JoyTester ...one is better than other though
- note I still have original pots hooked up too, as I was thinking I could use them perhaps as MMjoy Axis Special Functions and assign buttons or something else to them , or even use as throttle and Rudder if TQS is not in Use.
KB
Hi Kbird, Saved with center - you need for joystick, of course, you need center or not? And Saved w/o center is for throttle... when you do not need center position, ok? Precision- for TLE5011 set 14-bit (because TLE5011 has own ADC), for pot only 10-bit because you use internal Arduino ADC and it is only 10-bit precision, ok? Filter- value 0 means - without filtering, so for TLE5011 I usually use value 3-4, for new pot too, for old pot 7...you have to try it, it is clear I think. You can use Death zone if you want, eg. DZ low - DZ center - DZ high: 1-1-1. Sometimes 1-2-1 is better for some joystick gimbals. You have to try it too. Bye.
