I have "sucessfull" flashed my chip with a test firmware mapping one Axis.
The Device is shown in Settings -> Device and Printer as MMJ-reset...
any ideas whhat i #%&*$# up, gentleman?
Looks that you don't set the "joystick" already. The firmware flash make the Arduino a HID device, but not a "joystick".
Open the JoySetup, select the device "MMJ reset" and set the joystick:
Their name VID/PID numbers (eg. 0001/0001 make the new joystick the first for Windows/Games). Number, resolution, names for axis, etc. Matrix or Shift Register for buttons, set buttons "names" (their numbers). Can leave this for do latter. Save for device. When reboot the new joystick will appear in Joy Setup testing tools or Windows Control Panel > Games Controllers
Thank you! I overlooked that menue Point and thought after configuring i have to flash the Firmware on the Stick. I knew it had to be something easy I feel stupid now !6! HOURS of overlooking that Button
Ok, The Arduino now gets recognized as a Joystick in Windows! Too bad its already 1 AM, i think i can finally finish that Stick mod tomorrow (feels like an eternity) I will Post a Picture in here when it is finally assembled
