I would like to use this PCB, but I modify a little bit to use same wire order in every connection.
If I ask someone check this that is good:
http://simhq.com/forum/files/usergals/2016/05/full-20746-121923-teszt.jpg
Don't need any other to work the digital axes more than 10 bit?

What is the different between the reg and dig connection?
The led connection how many leds handled , how can I connect to use ,the normal leds are only 2 wire there is 3 pin .
Can I control more than one led individual?
I can connect the normal pots the digital axes place only GRD, VCC and for example D0?


I design my gimbal too, but even more work on it. I would like to use adjustable central spring bottom:
http://simhq.com/forum/files/usergals/2016/05/full-20746-121924-joy.jpg

there is make a hole on The red circle and one axis for handle axis. I plan to compatible with cougar handle so the top of the axis have an M36x2 thread

Last edited by Repvez; 05/21/16 07:04 PM.