The other day, I did some experiments with MMJoy2 20150727 and a Arduino Leonardo (from Itead). After a while I was able to understand and test a 2x2 matrix using directly some 1n4148. Today I wanted to go further and I am back some steps. I can see the stuff from MMjoy. I can load the programmed set. I can save the programmed set. Sometimes I have a error message like that: mmjoy error write config_hid.[A device attached to the system is not functionning] Sometimes I dont have it. My matrix is D4 D1 D2 D3 Button 1 2 3 4 declared as ---- After the restart if for exemple by 1N4148 is between D4 and D2 (Arduino D4 -|<|- Arduino D0), then 1 is red in MMjoy, anyway it is not red as a button input and not blanked when I unplug it. I dont see any refresh like if it was crashing on first state at boot.
What I am doing wrong? How can I troubleshoot that? Thanks.