Well, since we are hijacking this thread....

biggrin

We buy bar soaps to bathe with.

After a while when the bar gets to be too small or it breaks into two or more smaller pieces, no one wants to use it.

They are not big enough to lather up your body with during a shower or bath and too small to have enough washing power to wash your face with making you still feel dirty afterward.

It would be a waste to throw them away.

At over $4.50 for a pack of 8 4 oz bars, it gets expensive.

Especially when we use them in the shower, they break down faster sitting in wire soap holder on the wall with water splashing on it from the shower jet spray off the wall and your person.

I was wondering if we can put it into a blender and break them up into a mixture and then somehow mold the mixture into one big piece of soap again.