Hi mega_mozg

Thanks for updating mmjoy2 with curves.

However, I am rather confused in setting it.
Can you give me some direction?

With hall sensor, it seems that my center is not really the center.

This is my center (vertical black line):

Can I move it slightly to the left, so it can be really centered?


this is my extreme left position:



and my extreme right position:


As you can see my left/right extreme positions are still somewhere in the middle,
can I move it to the edge?

And there are zoom, stop, trim, divisor, and reduction.
What number should I put in it?

And there are DZ low, center, high, dynamical.
What are these for?

Please advise.

PS. for me, 8 axis, 4 hats, 64 buttons is enough.