K-9 cabinet, from right to left - 1.Operator for distribution of targets in RPC beam; 2. Operator of target distribution (between zrdn-s?); 3. Commander of the zrdn's group:





Left: Commander of the group:
On the glass of P-14's VIKO could be drawn some additional info, which helps the commander during engagement (here, per example, the border and the zone of responsibility is shown; 1 and 2 - strobs of RPC-1 channel and RPC-2 channel.

Down-left a rotating scale was used for quick determination of killing possibility - here the killing zone against cruise-missiles(KR), fighter-bombers(IB) and strategic bombers(SB) on high and medium (dotted line) altitudes.

Upper-right: 2. Operator of target distribution (between zrdn-s?) - After every channel starts tracking the target in AS, P (parameter) and T (time in killing zone) are calculate by the CVM (central computing machine). The data (Parameter and/or Time) is used by the Commander to make a decision for which target been attacked first.

a) screens before calculation
b) screens after calculation



Operator for distribution of targets in RPC beam:
After CU in "Leader1-Follower2", RPC of both channels (zrdn-s) is following one and the same target (upper part of the picture). After target distribution every channel (RPC) is tracking his own target.(note the left orange screen (target distinction indicator).



K-2B cabinet:

Left column indicators:

1. Target is in process of acquisition, MHI, Velocity tracking is on
2. AS-3, MHI, Velocity tracking is on
3. Target is in process of acquisition, MHI, Velocity tracking is off
4. AS-3, MHI, Velocity tracking is off
5. FKM, AS-4
6. Active, narrow beam noise jamming low intensity (self defense jamming)
7. Active, wide beam noise jamming, medium intensity

Right column indicators:

1. Group of targets, MHI, Velocity tracking is on, AS-3
2. Group of targets, MHI, Velocity tracking is off, AS-3
3. Tracking one of the tarhets, FKM, AS-4
5. Changing the tracking from target 1 to target 2in progress, RU (manual tracking) mode
6. Tracking target 2 in RU mode.
7. In case of Velocity Deception Jamming (Velocity Gate Pull Off) the tracking system might "take the bait" and start tracking the jamming signal. Activated modes - RU, Wide Velocity tracking mode, Auto-retracking on Velocity (KR-266V down left)
8. When certain level of velocity tracking deviation is achieved, the automating tracking strobe(cursor) is switching back to manual tracking (RU) strobe (cursor).




Next two should be familiar to the all dedicated SA-5 fans... wink :






Source: Source

Last edited by piston79; 02/19/14 09:22 PM.