Another possible bug in the SA-2F.
If you launch a missile with the proximity fuse off and with the switch in the approaching target position, and then after launch you move the switch to the receding target position, I think the missile is still detonating like it was set to detonate on approaching targets. And vice versa.
I'm not sure if this is a bug or if it's how the system works. But I thought I'd mention it.
Hi, I did a little test with SA-2F...
Ashuluk training ground, 3 radar reflectors, missiles are launched one against each target.
Fuse settings where as follows:
1 - "Dogon"
2 - "Rabota po K3"
3 - "Dogon", changed on "Rabota po K3" during flight...
Here the 3DAAR:
Second test was the same, but with 4 missiles against 3 targets and the fuse settings was not changed during flight (the sequence starts again with "Dogon", than "Rabota po K3" and so on...).
Here the second 3D AAR screenshots:
As debries pattern should looks like this:
please, share your opinion about realistic behaviour of the K3 command detonation of the warhead... PS. Due to poor quality of screenshots, i wish to mention that all measurments are in meters...
