A small update for this as well.
This design is also ready for machining, but before that I had to make some adjustments.
I decided to turn the whole gimbal system up side down. So the center of the gimbal can be as close as possible to the mounting plate, while I can use longer springs, and higher mechanism. It is important to keep the center close to the plate, otherwise I can end up with a huuuuge opening on it:)
I installed longer springs, so I can have some more pretension on them. Just like on the pedals I decided to use a simple steel mounting plate. The opening will be covered with leather boot.
Machinging is starting in June:)
Stick2Stick1And the two babies together:)
pdl+stick1pdl+stick2