I(+) - P(-) for Target Elevation
H(+) - J(-) for Target Range (Boresight)
L(+) - M(-) for Target Azimuth
Imo the arrow keys would be better.
Up = Increase elevation (slow)
Up + Shift = Increase elevation (fast)
Down = Decrease elevation (slow)
Down + Shift = Decrease elevation (fast)
Right = Azimuth right (slow)
Right + Shift = Azimuth right (fast)
Left = Azimuth left (slow)
Left + Shift = Azimuth left (fast)
Keypad + key = Increase range (slow)
Keypad + key + Shift = Increase range (fast)
Keypad - key = Reduce range (slow)
Keypad - key + Shift Reduce range (fast)
I really hope this will be implemented. For example, when you're engaging a jamming target with the SA-5, you have to adjust the altitude gauge with a control on a different screen. While this is very annoying I think the altitude gauge is in the correct place. It wouldn't make much sense if it were located anywhere else, same for adjusting the Square Pair elevation, the elevation indicator wouldn't really "fit in" any place else. However, being able to move the radar without having to even be on the same screen would eliminate this problem entirely.
Idea is noted, just keep developing it...
... keys for missile launch, high voltage on/off, narrow/wide beam, range mode selection...
(space is already reserved for the Shilka fire trigger)
Hi!
Some thing are always annoying me when I use SAM Simulator, and I wouldn't talk about it,
(to not kill Hpasp in programing!), but I think know it's the time to talk about it!
look:
when we travel between different screen - to go to the different panel: EWR Scope, Plotting table(IADS), ...-
we use simple keys -W,X,C, Q,S, A,Z,Y- to navigate between, since beginning I ask my self, Why -W,X,C,Q,S,A,Z,Y- ??
not logic at all ! and not efficient for tactical mode, (in my humble view!), that's why I have this "wish" in my mind,
ONE PIC is more clear than thousand words: (Neva example with Up Down Left Right keys only)
