I(+) - P(-) for Target Elevation
H(+) - J(-) for Target Range (Boresight)
L(+) - M(-) for Target Azimuth
Imo the arrow keys would be better.
Up = Increase elevation (slow)
Up + Shift = Increase elevation (fast)
Down = Decrease elevation (slow)
Down + Shift = Decrease elevation (fast)
Right = Azimuth right (slow)
Right + Shift = Azimuth right (fast)
Left = Azimuth left (slow)
Left + Shift = Azimuth left (fast)
Keypad + key = Increase range (slow)
Keypad + key + Shift = Increase range (fast)
Keypad - key = Reduce range (slow)
Keypad - key + Shift Reduce range (fast)
I really hope this will be implemented. For example, when you're engaging a jamming target with the SA-5, you have to adjust the altitude gauge with a control on a different screen. While this is very annoying I think the altitude gauge is in the correct place. It wouldn't make much sense if it were located anywhere else, same for adjusting the Square Pair elevation, the elevation indicator wouldn't really "fit in" any place else. However, being able to move the radar without having to even be on the same screen would eliminate this problem entirely.
