Here's the parts you need:



The parts shown are a 22MM bearing (just a little shy of 7/8" diameter), two 1/4 x 1/4 neodymium magnets, an Allegro A1302 hall effect sensor and a Bic pen body.

Using a vice, carefully press in a short segment of pen body into the bearing - do NOT hammer it! The pen body plastic is very brittle. Steady force using a vice will "drift" in the pen body quite easily.

Next, glue the two neodymium magnets to opposite sides of the pen body - the magnets should be oriented N-S (they'd come together if the pen wasn't in the way). The way I did mine was to rest the magnet on the inner race of the bearing with a business card keeping it from physically touching the race. I then used "thick" CA (cyanoacrylate) to glue the magnets in place - have some kicker handy to speed up the cure process.

You should end up with something that looks like this:



Now you need to build the board that will hold the sensor in place. I used a small slice of copper clad perf-board. This holds the 3 pin connector and the A1302 very well.



Next, you want to get some 1/2" or 3/8" plywood and bore a 7/8" diameter hole in it using a forstner bit. Dont' bore the hole completely through - leave about 1/8" of material. Then drill a 1/4" hole using the same center as the 7/8" hole. I use a set-screw to hold the bearing in, but you could easily hot-glue it in if you're careful to keep the glue out of the bearing races. Tape the bearing in for now so you can align the hall sensor properly. A properly aligned sensor will fit in the center of the pen body with the magnets on either side of it.

You should end up having something that looks like this:



Assembled, it should look like this:





You can connect any kind of pushrod arm, gear, or whatever to the pen body - just don't apply too much side force to it. Too much side stress will crack the plastic. This setup gives 180 degrees of usable travel and works very well! The bearing size that you get should have an inner diameter just a tiny bit less than the widest point on the hexagonal Bic pen body. This allows for a very tight friction fit that doesn't require any adhesive to hold it in place.

You can easily custom design your own bracket for this - this was a simple prototype that proved out the technique and a refined version will end up in my '109 as well as a replacement for the pitch axis sensor I screwed up in my BRFS gimbal build. smile

Enjoy!

g.


Proud owner of 80-0007
http://www.f15sim.com - The only one of its kind.
http://geneb.simpits.org - the Me-109F/X Project