Woffers using G-Sync monitors

Hi Folks;

I could use a little help here.
I am interested in what settings you have specified in the following NVIDIA Panel (see attached pic).
I am looking to see what optimizations I can apply on my G-Sync monitor.

Best Regards

Here's what I use:

ambient occlusion - off
anisotropic filtering - 16x

antialiasing
fxaa - off
mode - override any appl. setting
setting - 8x
transparency - off

monitor tech. - G-sync
power mgmt. mode - prefer max. performance

texture filtering
negative lod bias - clamp
quality - high performance

triple buffering - on
vertical sync - on

Thanks Hoongadoonga! I was beginning to think nobody would reply to this thread. I will try out your settings.

Hi Robert, Will post mine over the weekend. Not sure how tweaked they are.

Thanks Stache. I am willing to try all offers. Nothing ventured, nothing gained I say!

I also use the following settings within WOFF:

anti-aliasing - 2 samples

v-sync - driver setting

Not off your settings are show up, another point are you sure that samsung sync master is a Gsync monitor?

It's an ASUS ROG PG27AQ not a Samsung. The Samsung is my second monitor now.

I know all the settings didn't show. That is not so important to me. I just wanted to show the panel I'm interested in. I would however be interested in all the settings for that panel that other people have set.

Thanks for your reply.

I use Nvidia Profile Inspector

ASUS ROG PG348 with GTX 980

Frame Rate Limiter 77 FPS (depends on your system, but should be just under you typical average to minimize stutters)
Limiter Mode V2 - Allow All
Antialiasing compatibility 0x004412C1
Full Screen only G-Sync
Vertical Sync Forced Off
AA Mode Override and application setting
Antialiasing 4x Multisampling
Transparency 4x Sparse Grid Super Sampling
Anisotropic 16x
LOD Bias On
LOD Bias (DX) -1.0000 (matches 4x SGSSAA to sharpen textures)
Texture Filtering High Quality
Power Management Prefer Maximum Performance

Thanks for the input Major

Major, what version of inspector are you running and where did you download it from?

It's at Guru3d

Version 2.1.3.10

Developer Thread

Hi Robert, well appears mine are not tweaked at all.

Somewhere along the line they have reverted back to default.
Got to admit though - does not seem to have affected my flying and enjoyment of WOFF.

This is on an factory OC 980ti on three Acer XB271HU WQHD Gsync at 7780 x 1140 resolution.

Couple months back I started campaign flying in mid 1918.

Thank you for having me check this.
I will need to revisit.

No problem! Keep me posted if you manage to make any improvements. Always looking to tweak things!

For those of you who may be interested, I have found the best Nvidia control panel 3D performance settings for my ASUS PG27AQ 4k monitor so far. If I should find more improvements I will update this thread. My Nvidia card is a GTX 980Ti

My ASUS PG27AQ is running in native resolution of 3840 x 2160
In WOFF I have the following settings:


In the Nvidia Control Panel 3D settings I have the following settings:
3D Global Settings Page1:


3D Global Settings Page2:


3D Program Settings Page1:


3D Program Settings Page2: