I am looking for the detailed instructions for installing the Cubpilot Hall Sensor Kit into the Cougar stick and throttle. These instructions used to be hosted on Cubpilot's Website and now the website is no longer available.

Do any of you kind souls have a saved hardcopy/softcopy that you can share? Thank you in advance.

I believe I found my hardcopy last weekend when cleaning out my garage... I might be able to help you out tomorrow afternoon, if you haven't gotten another response by then. I'll see if I can dig it out (if I'm right, it's in the bottom of a plastic tub that has four large tubs on top of it).

RogueSqdn,

Thank you and

Cub Pilot reincarnated


maybe this will help..

The Nephilim,

Thank you Sir!

However, I have trouble with the graphics on some of the pages. Specifically, the graphics did not load for me on pages 44 to 47.

Crap, I forgot. Give me a little bit.

Here you go. Sorry I took this long.

It's old, so parts might be difficult to read or see, but I hope it'll help.

This is just for the throttle. I never got a kit for the stick (I have both the FSSB R2 and R3). There's a warning in the doc, but I'll repeat it... the diagram can't be used on the stick, it will damage it. Use it only on the throttle.

Rogue Sqdn,

Thank you again!