I thought you might like to see my 14th 1:32 scale build - The Bleriot built Spad XIII C.1, Number 26 of ‘C’ flight, 27th Aero Squadron, 1st Pursuit Group, based at Rembercourt, near Verdun, France during September 1918. This was one of the Spad XIII’s flown by Francis ‘Frank’ Joseph Anthony Luke Jnr, the ‘Arizona Balloon Buster'.
This kit is the old Hobby Craft Spad XIII 'International' kit, which is I believe was the only 1:32 scale of the Spad XIII made. The kit was, as expected, fairly basic and had no engine at all. In fact the whole forward fuselage was blocked off.
I didn’t recall ever seeing this kit made with an engine installed
, so I decided to give it a go.
The basic list of changes/additions to the model are:
Radiator shutter control rods
Radiator drain valve.
Cockpit head rest support frame.
Fuselage internal storage and cross members.
Decking panel right gun - ejection chute.
Forward gun mounting brackets.
Engine access panels - wire mesh.
Tyres spokes and valve.
Ventral fuel tank cap.
Fuselage lifting straps.
Fuel tank rip (jettison) panel.
Oil cooler drain valve.
Ring gun sight and mounting bar.
Wing inboard 'H' struts.
Wing outboard rear struts.
Wing strut rigging fittings
External aileron operating bell-crank and rods
- Fuel, oil and vent pipes
- Cockpit frame wire bracing
- Additional instrumentation
- Instruments pipes/cables
- Gun firing cables
- Fuel rip panel T-bar handle
- Mallet (freeing gun stoppages)
- Pilot's seat cushion
- Rudder bar foot straps
- Top frame above pilot's head
- Rudder, Aileron and Elevator cables
- Pilot’s seat belts.
'Wingnut Wings' Hispano-Suiza V8 engine built (detail modified)
- Ignition leads, support tubes and magneto connection
- Engine support beams
- Carburettor air intake
- Air breather and pipe
- Fuel manifold primer valves
- Cooling/heating system pipes and filler.
- Gun cooling jacket ‘stay’ rods.
Various fuel, coolant and control rods.
Modified or corrected:
Rudder, Ailerons and Elevator animated.
Louvres in engine panels opened.
Engine valve gear cooling fairings drilled.
Forward decking panel separated.
Engine cowl cooling apertures created.
Fuel filler aperture.
Cockpit surround panel modified.
Forward fuselage, decking panel and cockpit floor modified.
'Aviattic' Spad XIII wheels (modified).
'HGW Models' seat belts.
'Gaspatch' .303 standard Vickers machine gun (modified).
‘Gaspatch’ Vickers ‘Balloon’ machine gun (modified).
'Albion Alloys' micro-tube.
'Polak' grass mat.
'Aviattic' and Copper State' figures.
'Airscale' instruments bezels.
The following shots show where I'm at right now.
The next step is to start fitting the upper wing prior to rigging.