Started this project about 15 years ago, been collecting dust for the past 13, wanted to finish it but got into racing, then I moved to California and got into fishing, then went back into flight simming but WW2 planes and not going back to jets so I'm selling it
When I started that project my plan was to built like a case mode, computers inside, lots of room , then using servos, stepping motors to drive the gauges. Each gauge have their needle, At that time there was no plans, no dimension for that panel, only a few pics so it's probably on the small size 30"1/2 W x 16" H x 24" deep, I don't know. I even built a CNC to make the side panel, I might sell that too later on
Pick up only and asking $150
Any question just ask
Marc..