I'm wondering if anybody has experienced this:
I programmed switch macros to the left and right ENG OPER switches on the Warthog throttle base. With 3.0.16, I don't get any macro response when toggling the left switch between NORM and MOTOR. The right switch works just fine. I've verified in Device Manager that the left switch is properly detected, and I've also tested with a program that worked prior to the update and have the same issue. I've also rebooted and attempted these steps again with the same results.
Has anybody else experienced this?
I'm using Windows 7 x64 with TARGET 3.0.16 and a
HOTAS Warthog,
HOTAS Cougar, and 2 F-16 MFDs.