Been looking at it quite a bit, but haven't finished it yet!
Servo tray has been replaced with a new (wood) one, much lower in the fuse so as to give adequate room for the control rods.
I was all set last Spring to bring it out and break in the engine on it, but found out that the plywood piece that has the screw holes for mounting the wing was too high (though it was built per plan) so the control rods for the aileron were in the way and the wing couldn't be mounted. Figures. Just one thing after another with this build.
I've fabricated a new piece, and am (on and off) in the process of figuring out where it should be mounted to be out of the way of the rods. I'm also toying with the idea of turning the mount block into 2 pieces rather than one. If I support it right underneath, it will be plenty strong enough. This is also more of a "Sunday flyer" ie relaxing circles around the field rather than an aerobatic sport plane (that's what the Ultra Sport is for) so it won't have to deal with huge stresses.
Of course, the way this build has been going, it will fold up or explode midair on the maiden flight anyway!
Thanks for checking in!