Hey all, I wonder if anyone can help me clear this up. I always seem to be a good twenty yards off with my LGB impacts... any idea why? I originally releasing them as follows:
- No options set up in DSMS, simply selected GBU-12
- TGP Latch ON
- Lase target and set TGP look point as SPI
- Turn off laser
- Ensure HUD is in CCRP mode
- Line up on target, wait for countdown
- Hold down Weapon Release button at the 5 second mark
- Immediately lase again and keep TGP on target
Using this I kept being just a bit off, so I went and did the relevant training mission (one of the few I'd neglected) and did the following:
- DSMS profile page
- AUTO LASE set to ON, 10 seconds from impact
- Save profile
- Set TGP look point as SPI (no lase)
- Ensure HUD is in CCRP mode
- Line up on target, wait for countdown
- Hold down Weapon Release button at the 5 second mark
- No manual lase during fall
With this method I was spot on first time around, but then my second try yielded the same disappointing impact two-dozen or so yards from the practice target. Any ideas where I'm going wrong?
One final note: I originally wondered whether the "flashlight effect" was meaning that my SPI was actually designated some distance behind the target when I didn't lase, but my final attempt last night saw the bomb fall short of the target... I'm a bit stumped!
Thanks all!
