When I land at an airbase and rearm the new payload doad doed not show in the dsmd page on the left mfd, can you help here. How do I get it to show?

YOu have to load it up and refresh the DSMS page. SOmeone will come along with more knowledge than me and give a step by step, I am sure. Good luck.

yo have to shut donw the MFD"s ( switch on the left down by the IFCC switch then get your new load out turn on MFD power again then do the DTS load all....

You can also reset/reload the the weapons load out without power cycling the IFCC, not sure were int the manual, but this subject was in the early Beta forum pages,, (I still power cycle IFCC )

Lol, no need to do all those.

Just long-press one of the bottom-row OSBs to bring up the LOAD page. I usually select OSB 12 (STAT page). Long-press it, about 3-5 seconds, then a menu of pages will appear on the MFD. Select LOAD (OSB 8 IIRC), then press OSB 12. This should change OSB 12 from STAT to LOAD. Then short-press OSB 12 again, and should bring up the LOAD page, similar to what comes up during startup sequence. Select LOAD DSMS (OSB 18 IIRC), wait for it to load up, and you're done!

You can re-set OSB to STAT once you're all done if you want to, just follow the steps above and select STAT from the list and set it to OSB 12.

Thanks Guys

cool ice thx a lot for that info ..... learn something new everyday! ----Longreach

No worries guys. Glad to have helped.