I have coded on one key both a TDC priority and Mode change. For example
IF( JS1.B10 ) THEN
CURRENTMODE = MODE1;
ELSE
IF( JS1.B11 ) THEN
CURRENTMODE = MODE2;
ELSE
IF( JS1.B12 ) THEN
CURRENTMODE = MODE3;
ENDIF
ENDIF
ENDIF


What this was to do is to enable me to change the TDC priority and change the Mode on the MFD (since I have only that has to act like 3). It works for the right and left MFD but the bottom Mfd will not work. I have no idea why 2 out of 3 work. I also tried to put a delay in but still no joy. See below.
//sequence
// wait( js1.b10 );
// delay( 10 );
// CURRENTMODE = MODE1;
//endSequence

//sequence
// wait( js1.b11 );
// delay( 10 );
// CURRENTMODE = MODE2;
//endSequence

//sequence
// wait( js1.b12 );
// delay( 10 );
// CURRENTMODE = MODE3;
//endSequence
endScript
At this point, I will just go to the bottom mdf and use the mouse until I can figure out why it wouldn't work.

Have you tried using it in the red hardware mode?

I have cleaned up some of the issues in your cmc file and everything is going ok except for 3 issues.

first, my throttle increases when I pull back and i cannot get it to go the other way no matter what i do.

second, my rudder in ch is set for cm device 2 r axis and in TSH I have it set for R2 but in the game it goes crazy.

third, I am still working on the sensitivity of my joystick and trying to use the alternative in TSH.

However, on balance, I still prefer Falcon AF.

Yes, I read, and replied

In CM did you happen to check Reverse Axis?


You can also adjust the Gain and Sensitivity in CM:


The rest, I'll look into when I get home...

I tried both ideas last night and no joy.

Gatta be something in how TSH is interacting with CM then? And or how the controller USB assignments in TSH are assigned?

Well, I was able to figure out that, for whatever reason, the sim still does not like multiple controllers (in my case anyway). Finally had a few minutes to get into the cockpit and with my multiple (not combined in CM) .map, I had no throttle control. With a .map acting as a single device, I have a throttle, in the sim.

I am still experiencing rudder issues. when I try to take off, the plane veers way to the right. When I use only the keyboard controls for the rudder, everything is ok.

I now have noticed that in the game, the throttle appears to only go to 50% when you try to set the Mil power line.

I am still experiencing rudder issues. when I try to take off, the plane veers way to the left. When I use only the keyboard controls for the rudder, everything is ok.

I now have noticed that in the game, the throttle appears to only go to 50% when you try to set the Mil power line.

Maybe I have to combine the sticks and the rudder and throttle issues may go away?

Ghost
If I combine the sticks, does that mean I have to relabel each stick? That would be a real pain for the MFDs.