Hey guys! I'm planning to do a basic 'pit but this time with the center-stick configuration. I'm just putting this thread out to look for possible 'pit configurations (how the woodwork is layout).

What I basically want to do is have a layout that has the chair, throttle, stick, and front dash all together. The chair will probably be an old car chair that I can salvage, the "front dash" will hold my keyboard and Cougar MFDs, maybe a 2nd screen if I have one. I prefer for these to be one "setup" so that it is stable, though I may assemble with screws to be able to swap and mod later on. I've had a good look through these forums but have not really found one that appeals to me, maybe you've got other ideas?

One of these years I'm going to build a ABC pit...

http://www.62ndfightingfalcons.asn.au/Re...74/Default.aspx

Yeah, but that's a side-stick configuration.

Also, this 'pit will be used with a TM Warthog using metalnwood's extension. This means the joystick mount will actually be below the seat height... now I'm deciding whether I'd need a curved extension or not.

Did you have a look at my WIP ?
It's somewhat simple to build, and can easily be modified with an instrument panel. I plan on adding one myself, with two 8" screens and the Cougar MFD's later on.

I've seen your WIP, yes, and I am thinking of a somewhat similar build design. The only major difference is that with the warthog extension, my stick base will actually be mounted BELOW the seat level, not above. So my concern is 1) do I mount it a bit forward and below so that the stick does not hit the seat or 2) do I find a seat with a cut-out or maybe make my own seat or 3) do I make a curved extension for my warthog?

Can I ask you though, what did you use to cut the MDF especially the curved areas?

Ah, I see.
I thought about making a cutout in the seat too, but I ended up just pressing the stickmount into the foam edge of the seat.
I think a cutout would be possible, atleast with the type of seat I have, as there is nothing but foam in the front edge. It might be a bit difficult to make it look neat afterwards though, but with needle and thread + some patience I think it could work.

As for the curved cuts, I just used a jigsaw with a sharp blade. It will take a bit of sanding to get a nice finish, but it's not that bad.

I see. Very nice work though. I think I'll design something easier to cut Still, I've yet to assemble my DIY "gear" over here so may be a few months. I'm also still contemplating on the seat-and-stick design.

Hi Ice
I`am building my centerstick DIY. It is an old Suncom f15(on the top) and an Thrustmaster Hotas Stick as the bottom part.
My pit is for racing, flightsim and Ego-Shooters. (i´am still working on it)

Sorry this side is in German, but I hope I could help you.

http://forums.eagle.ru/showthread.php?t=50722&page=4

regards
toyojoe

Sorry, should have been more specific. There is no rule that Aker-Barnes Pit has to be side mount.

Ice,
I recently mounted my Warthog as a center stick in my pit. Dudley Simpit Center Stick

If you are going to floor mount it, just extend either the center PVC pipe so you don't have to mod the 'hog at all, or your can build an easy extension like I did. Dudley Simpit Extended and Offset Stick

You can occasionally find some commercially available stick extensions here and there, but I haven't tried any of them.

Anyway, just some ideas and info.

Good luck!
Dud