It is rather large, and thus I've made it heavy to move. Here it is on the nose of the AEG G.IVK model:

http://www.quarry.nildram.co.uk/HW26e.jpg

And here you can see one mounted on the nose and rear gunner station:

http://worldatwar.net/chandelle/v2/v2n1/aeg_g4k.gif

Avimimus and Sport, PMs sent your way with the aircraft and some notes.

I finally had a chance to take it up, it had been a while sence I have flow SDOE. I have run into a controller issue. I am try to use my CH Fighterstick as a free standing stick and cannot seem to be able to control the throttle with my stick wheel or the key board. Also how do you take over the gunner positions?

Thanks

Hello!

Try this:
If you can't get FS-WWI to recognize your joystick in the 1.6.x.x Patch, please do the following:

Open up the keyboard.inp file, located where the 1.6.x.x Patch is installed, in wordpad and find the lines:

inpThrottleAnalog = JoystickSlider1 : 0
;inpThrottleAnalog = JoystickAxisZ : 0

Once you find those, switch around the semicolons so it reads:

;inpThrottleAnalog = JoystickSlider1 : 0
inpThrottleAnalog = JoystickAxisZ : 0

When you have made those changes, save the file. Make sure you do not save the keyboard.inp file as a *.txt file or a word document! Yours may be the other way around; if so do the same only reversed. Also, launch the FSSDOEJoystick.exe program located where the 1.6.x.x Patch is installed. This will help you assign axis of your joystick.

To take over a gunner station, press F7 to cycle and F6 to take over.

Thanks,

My day off is tommorrow, I will give it a shot.