Hi all, Well the fuselage is completed, apart from fitting the engine exhaust and the propeller. The Rudder and Elevator control runs have been connected with the turnbuckles under the pilot's seat. Also the tail plane to fin bracing cable. The entire fuselage has been weathered and sealed.
So now it's on to the lower wing, followed by scratch building the skeletal undercarriage assembly, which unfortunately is not available as a 3D printed part.
Mike
Last edited by Sandbagger; 05/16/1904:25 PM.
Alienware Aurora R5 Windows 10 64 bit Intel i7-6700K 4.2Ghz Two GTX 1080 Foundations in SLI (8 Gig each) 32 Gig DDR4 2133Mhz 1TB SSD boot drive - 1TB SATA storage drive 5.1 Surround Sound 34" Dell Ultra Sharp U3415W (3440x 2440) CH Pro-Pedals, Stick and Throttle TrackIR-5 Pro