Hi all,
The kit supplied fuselage side frames married to the 3D printed fuselage.
This required cutting both, as both have a pilots seat frame and only one can be used of course.
As the join between the two could be a weak area, I chose to fit them together using brass micro-tube.
This gives more rigidity to the join of the fuselage and allows the fitting of the pilots seat frame from the kit (part A26),

Mike

[Linked Image]


[Linked Image]

Alienware Aurora R5
Windows 10 64 bit
Intel i7-6700K 4.2Ghz
Two GTX 1080 Foundations in SLI (8 Gig each)
32 Gig DDR4 2133Mhz
1TB SSD boot drive - 1TB SATA storage drive
5.1 Surround Sound
34" Dell Ultra Sharp U3415W (3440x 2440)
CH Pro-Pedals, Stick and Throttle
TrackIR-5 Pro